In with the NucleuS

23 October 2009

The new NucleuStechnology developed by AT&S is a method for volume production of individual PCBs.

It makes optimal use of the production format and only connects them to their frames just before they are shipped out to assemblers for assembly, which brings cost advantages and improves efficiency.

The end product of PCB production is the panel, which consists of a number of printed circuit boards, as specified by the customer, held together by a frame. When the panel has been completed by the PCB manufacturer, it is shipped to an assembler which mounts the various components.

Ideas for manufacturing frames and printed circuit boards separately and assembling them in the most suitable form before sending them to the assembler have been around since the 1980s, but until now all of these approaches have been unsuitable for mass production, and no cost-effective production methods have been found.

AT&S’s NucleuStechnology, developed at its Leoben-Hinterberg and Shanghai plants, does not have these drawbacks, and promises considerable increases in efficiency. Firstly, the PCBs are produced individually, and then they are inserted in a standard assembly frame. The special process developed by AT&S has the same tolerances as the existing production method.

Advantages of NucleuStechnology include more efficient use of the production format (normally, several PCB panels are produced on one standard-sized panel; eliminating the frame means that even more printed circuit boards per panel can now be produced). Furthermore, it reduces costs (the frame, which until now has been produced with the same layer stack-up as the printed circuit boards, can now be manufactured using simpler, cheaper technology). In addition, there are lower assembly losses because defective printed circuit boards are weeded out immediately (until now, either the whole panel was scrapped – even if only one board was defective – or the assembler was unable to work at full efficiency because individual defective boards that were not to be populated were running through its production process). Increased flexibility is also achieved, because printed circuit boards using a variety of technologies (single-sided, double-sided, multilayer and HDI) can be assembled into a single panel to the customer’s specification. And finally, more environmentally friendly production results from a lower use of materials and fewer rejects.


Contact Details and Archive...

Print this page | E-mail this page